HELP!! Problems with Hot while crank wiring

[ulev1st]

I am attemping to wire everything up so I can install my tuner next week.
The H&S book says that the capped off bundle of wire near the OBD port have a purple wire that will provide what I need..
I located said wire and tapped into but I have NOTHING..I tested a FEW more ..NOT ALL of those wires that are bundled and capped and got nothing on any of them..
Am I in the right spot?
Where is a good place to find a HOT WHILE CRANK wire for the Mini Maxx?
Not sure if I'm messed up or what..

[powerstroke43]

I think those are the pass through wires. The other ends are not attached to anything and are in the engine compartment.


Sent from my iPhone using Autoguide

[ulev1st]

Ok.....Where is a good source to pick up 12 v switch HOT WHILE CRANKING wire?

[powerstroke43]

My mini came with a fuse tap. The fuse box is on the drivers side under the hood. I think it was fuse 53? H&s has the instructions. I just ran the wire through one of the firewall grommets. You have to cut the end off the grommet and pull out the little rubber plug.


Sent from my iPhone using Autoguide

[ulev1st]

Cool...Thanks...got it wired!