truck wont start

[Rocken1]

do you have to have the sensors hooked up after you install the new pipe or do i have something else wrong I have the sct delete tune?

[Pahrump]

You have to hook the sensors up.

[Rocken1]

thanks for the info. do you think it screwed anything up? the truck did start after the new exhaust was put on.but after that is when it would not start again.

[Pahrump]

Put everything together, and clear the codes, then start it.

[Rocken1]

how do you clear the codes to get it to start? And is it just the pressure sensor that needs to be put back on or all the sensors?

[Pahrump]

All sensors.

You use the tuner to clear the codes.

[Rocken1]

thanks for the info i hope this works.

[Rocken1]

okey I put all the sensors in the truck cleared the truck of all five codes and the trucked will not start. I called sct and they said it might be a dpf tempature sensor. I'd like to know if this is problem and what it looks like. there are 3 probes on the exhaust and one black box with a rubber tube which one could it be? Or a part number on the one that could be bad.

[Pahrump]

The temp sensors are the 3....theres 2 in the cat, and one in the DPF.

Hard to tell if its messed up by looking at it, unless you actually broke it or something.

[Rocken1]

what is the little black box with the tube on it? what does it do? on the probes i talked to the local dealership about buying one if one is broke they said it would cost 118.00 each. so even if just one of these is broke it shuts the truck down? The truck did start after the delete program and the exhaust was installed but with out the sensors the place I took the truck failed to install the sensors even though I told them they had to be there they drove the truck around the block and ran great so im told after that is when the tuck would not start again.