Minimax Dash Mount

tonsofduty · #1 (**permalink**) 09-21-2012, 07:55 AM

Does anyone on here have the new molded mini max dash mount? I got it, and it looks and fits great. The only problem is the wire seems to have no route out of it, so the tape does not hold it. What am I missing? I installed the intake in about 40 minutes with ease and this little piece of plastic is getting me...unreal

**Powerage** · #2 (**permalink**) 09-22-2012, 05:47 PM

The hdmi wire goes out the back under the a-pillar trim. The tape on it does suck though.

AllGo'N'Show · #3 (**permalink**) 09-23-2012, 07:39 AM

If you get the length right (leave bulk below by the OBDII port) then you can run it down the weatherstripping and use just enough hdmi cord to hold the plastic mount on the dash. Problem is anytime it gets bumped it takes u forever to put it back together, I've had enough of the crappy mount and am going to double up a BlendMount with my radar hopefully they fit together.

From DKrazyKracker32@PSN.com

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Remove Advertisements Sponsored Links
Powerstroke.org Advertisement