MBRP Pictures

tbsimmons · #1 (**permalink**) 10-07-2010, 02:08 PM

Can everyone post pictures of the MBRP DPF back kits. I searched and did not find any. I am interested in how far past the fender the pipe exits. Reason is I am going to mod the exhaust some but would like to get ideas before I start cutting and welding.
Thanks.

clutchdabomb22 · #2 (**permalink**) 10-07-2010, 03:58 PM

not sure its what ur looking for but i just run a 6"mbrp tip off the turbo back,

tbsimmons · #3 (**permalink**) 10-07-2010, 04:10 PM

How far does the tip get slid over the end of the tailpipe?

clutchdabomb22 · #4 (**permalink**) 10-07-2010, 04:22 PM

i wanna say atleast a good inch buy you could honestly slide the tip over the whole end of the pipe( i wouldnt, it would take away from the tip) but youcould, i would say the minum is an inch to 2 inches of pipe u need to clap onto

tbsimmons · #5 (**permalink**) 10-07-2010, 04:34 PM

Thanks. How much does the MBRP tailpipe gets stuck into the tip? Not how much the tip needs. I think I am asking that right.

clutchdabomb22 · #6 (**permalink**) 10-07-2010, 04:55 PM

My trucks at home and im out of town il find out when i get back

clutchdabomb22 · #7 (**permalink**) 10-10-2010, 07:53 PM

clutchdabomb22 · #8 (**permalink**) 10-10-2010, 07:54 PM

tbsimmons · #9 (**permalink**) 10-11-2010, 07:24 AM

Right on.
Thanks.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Remove Advertisements Sponsored Links
Powerstroke.org Advertisement