Would this work

FX4STROKER · #1 (**permalink**) 07-21-2009, 06:25 PM

I posted this in the sled pull section but didnt get any anwsers. I was thinking about making something like this for my truck. I have the plates off my old truck to bolt ontop of the springs. I kinda stole the idea from a set of caltracs and a setup I saw on here. Let me know what you guys think. INPUT IS WANTED!!!!!

**colberjs** · #2 (**permalink**) 07-21-2009, 06:29 PM

strokerguy · #3 (**permalink**) 07-21-2009, 06:30 PM

i have no idea so heres a

DavidPhillips · #4 (**permalink**) 07-21-2009, 06:40 PM

Is it going to be adjustable?

#5 (**permalink**) 07-21-2009, 06:52 PM

hmmmm im gonna have to think about this for a min....

FX4STROKER · #6 (**permalink**) 07-22-2009, 02:13 AM

Quote:

Originally Posted by DavidPhillips

Is it going to be adjustable?

yes with heim joints

rankroddin250 · #7 (**permalink**) 07-22-2009, 03:08 AM

Im sure it would work to make your truck ride like crap.

FX4STROKER · #8 (**permalink**) 07-22-2009, 03:16 AM

Quote:

Originally Posted by rankroddin250

Im sure it would work to make your truck ride like crap.

They will be track only! I dont need them on all the time cause they will bind when I tow. I just want to be about to pin them in and go then after im done at the track take them out.

Jesse.James · #9 (**permalink**) 07-22-2009, 03:18 AM

looks like it might work, i dont know

rankroddin250 · #10 (**permalink**) 07-22-2009, 03:22 AM

dont look like it would be to complicated to fab up. Its woth a shot to try and if it dont work just re use your heim joints to make some good track bars for it.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Remove Advertisements Sponsored Links
Powerstroke.org Advertisement