PMF Tractions bars

Jimbo33 · #1 (**permalink**) 09-22-2012, 12:14 PM

I just ordered PMF traction bars through Trevor yesterday. And I should be receiving in about 3 weeks... I went with the 5 in blocks and 2.5 taper along with 3/4 U-blots.. anyways, any advice for the install would be great!

strokinpower · #2 (**permalink**) 09-22-2012, 12:17 PM

nah they should go one pretty easy and you will love the difference they make!

Jimbo33 · #3 (**permalink**) 09-22-2012, 10:32 PM

I'm assuming you have them? And how is your tranny holding up with all those mods? Stock tranny?

strokinpower · #4 (**permalink**) 09-23-2012, 04:19 AM

I have newton traction blocks. Stock tranny, she takes a lickin and keeps on tickin.

Jimbo33 · #5 (**permalink**) 09-23-2012, 08:15 AM

Sweet deal.. Yea I can't freaking wait!! You put them on yourself?

strokinpower · #6 (**permalink**) 09-23-2012, 08:34 AM

Yes essentially. Just get good drill bits.

**PGreenSVT** · #7 (**permalink**) 09-23-2012, 09:23 AM

I have a bunch of pics of my PMF suspension install in the suspension section. Do a search on my posts in that section.

Trevor did his 4 link prototype for my truck. I run the 4 link with 4.5" ICON/DR spings and shocks, PMF 5.5" traction blocks and traction bars. Install is easy.

Jimbo33 · #8 (**permalink**) 09-27-2012, 03:00 AM

Nice looking truck.. I'll be sure to get some before/during/after pics for sure!!

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Remove Advertisements Sponsored Links
Powerstroke.org Advertisement