Hey guys , Im getting super close to installing my lift , i have a 8" BDS 4 link kit w/ 8" replacement rear springs ,just picked it up tonight from powdercoating!! ,I will run a set of 38x15.5x20 mickey thompson mtx, cant wait,
Anyway my question is , I understand going with a 10" lift i need to start worring about front drive shaft xtension ? and a couple other issues as i go up , Will i be okay to add say a 1-2 " tei spacer or top of the coil spacer up front and/or run a 1-2" block under spring in rear ? Or will i start having issues ? any help would be appreciated , i have read alot but just getting so close to doing this i just want to do it right -thx
08-03-2012, 07:12 PM
Linear Mode
