Additional lift?

[08spartan250]

I'm dont know all that much when it comes to lifts/and their parts. I have a 6" skyjacker lift and i'm wanting a little additional height. but i dont have the money to buy a new lift. any suggestions on what i could do to get another couple of inches? thanks!!

[Pahrump]

Spacers in the front...larger block in the rear.


You may need to add an adjustable track bar to center the axle...


I took a 6" radius arm drop kit to just over 10" with 10" coils in the front, 10" OUO traction blocks in the back, caster adjusters, adjustable track bar and of course new shocks.

[08spartan250]

Originally Posted by Pahrump

Spacers in the front...larger block in the rear.


You may need to add an adjustable track bar to center the axle...


I took a 6" radius arm drop kit to just over 10" with 10" coils in the front, 10" OUO traction blocks in the back, caster adjusters, adjustable track bar and of course new shocks.

say i just wanted to go up to 8". could i just buy 2" spacers and replace the blocks with 8" blocks?

[Stroke4Fun]

2" spacers in the front and the traction blocks i have for the rear they are almost 8"
Chris

[08spartan250]

i found the 2" spacers online no problem. but i'm having a hard time finding the blocks. and suggestions where to look?

[choff1212]

Trevor at PMF, hes also a sponsor.

[Pahrump]

Originally Posted by choff1212

Trevor at PMF, hes also a sponsor.

Yup Trevor...tell him Scott sent you to him

520-465-7971

[08spartan250]

Originally Posted by Pahrump

Yup Trevor...tell him Scott sent you to him

520-465-7971

ok, so here's what i'm thinking right now. Im looking at a ProComp 2" leveling kit and buying 8" PMF traction blocks from Stroke4Fun. I think this will give me the look that i'm wanting without going with anything too extreme. what do y'all think about this setup?