![]() |
Please Visit our Site Sponsors
|
![]() |
|
![]() |
![]() |
|
|
| 6.0L Problems Forum Having Trouble? Post here |
![]() |
|
|
LinkBack | Thread Tools | Display Modes |
|
|||
|
Truck Cranks, but will not start
Hi,
I have been using ford-trucks.com but I thought i'd post my problems over here. I have a 2005 f250 6.0 Powerstroke, I have an auto enginuity scan tool with the for enhanced pack. The truck cranks, but does not fire. The crank position sensor, or something like that under the passenger side, was loose so I plugged that back in, but prior to doing this I actually popped the top fuel filter off, and checked to see if it was getting fuel up top, and it was. I bled the fuel system off down below, as well. It still cranks and will not start. With the AE tool i checked the following. WHile cranking.. FICM 48.5 IPR 50% ICP 1100-1500psi I bought a new fuel filter, and will install it tonight, as I haven't done it in about a year and a bit and I believe it's due. Any help would be much appreciated.
|
| Sponsored Links | ||
Advertisement | ||
|
|||
| Sponsored Links | |
Advertisement | |
![]() |
| Thread Tools | |
| Display Modes | |
|
|