Dropped clip into intake port

[Intrnlstorm]

OK so short story shorter,

Was doing oil cooler change, dropped a clip into the second or third intake port on drivers side. Tried magnet, can't see the clip.

What do I need to do to get it out? I took valve cover off already but I didn't want to go further yet

Joel

[usnavyad]

U dropped it through the oil fill on the valve cover

[Intrnlstorm]

In the port. Not my engine just a picture that I found

Joel

[Intrnlstorm]

Pretty sure it is in the third from the drivers side front. I'm afraid if I try to get it it will push it deeper.

Joel

[a2elvis]

Originally Posted by Intrnlstorm

Pretty sure it is in the third from the drivers side front. I'm afraid if I try to get it it will push it deeper.

Joel

yea if it fell in you need to get it out that may mean pulling the head.

[usnavyad]

Yeah god knows where that went no good buddy is say u need to pull the head

[Intrnlstorm]

I got it!!!! Oh my god I am ecstatic right now. I can't believe this

Thanks everyone.

Joel

[usnavyad]

Howed u get it

[NYC F-350]

If you dropped one of those injector clips down into an intake port, and was able to fish it out... Go buy a lottery ticket. Then when you get back to the truck, cover those damn ports!

[Intrnlstorm]

Made a long hook out of welding wire and tried "one last time" whats the worst that can happen at this point? Scooped and pulled slowly and out it came.

Joel