Does this look right?

[PSDMikeB]

Hi all,

My panel vents were not working, so I did some research in the forum and figured out it was a vacuum problem. Wow, this forum is an amazing fountain of knowledge and help!

I found a loose vacuum hose, and all is well. After the vents were working, I noticed another white connector on the vacuum pump with nothing connected to it. Can someone look at theirs to see if anything is connected?

pic attached, fitting in question circled in yellow oval. I suspect it is just the discharge for the pump, but can't tell for sure. 2005 F250 6.0L

Thanks!

MikeB

[Acidsniper]

I believe that's just a pressure release valve but I'll run down after this meeting and check mine out for you unless someone beats me to the punch.

[PSDMikeB]

Thanks Acidsniper, I appreciate your help.

[Acidsniper]

Just ran out and checked. There's the hose coming off the engine side that loops back around like in your pic. There's nothing on the right just like yours. Pressure release is my bet.

[PSDMikeB]

Acidsniper,

Thanks for checking on this for me. I appreciate you taking the time.

Thank you also for your service to this great nation.


Mike