SCT Help

JYB018 · #1 (**permalink**) 04-08-2008, 02:12 PM

I was trying to program my truck with a new X3 and it said error. Exiting please wait. And that is all is doing. Is it safe to dissconect it wait a little while and try again?

kinghawg98 · #2 (**permalink**) 04-08-2008, 02:39 PM

yea....on mine I accidentally turned the truck of mid program...that essentially kills the truck. I reprogramed it back to stock, then tuned it to what I wanted.

AvroAero · #3 (**permalink**) 04-08-2008, 06:00 PM

Its not safe but if it won't shut itself down you'll have to. Try and reload it after that and if not your gona have to get it reflashed to stock. Doubt it would start though.

JYB018 · #4 (**permalink**) 04-09-2008, 03:40 AM

Thanks for your help guys! I unplugged it and started over and it all worked out. I was just a little nervous about it.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Remove Advertisements Sponsored Links
Powerstroke.org Advertisement