how can I tell...FICM

4realestate · #1 (**permalink**) 12-08-2012, 08:18 PM

I purchased a ficm from a member here who said it had been tweaked to 53volts.
How can I tell what, if anything, has been done to it ?

Joe

**PGreenSVT** · #2 (**permalink**) 12-08-2012, 09:14 PM

Quote:

Originally Posted by 4realestate

I purchased a ficm from a member here who said it had been tweaked to 53volts.
How can I tell what, if anything, has been done to it ?

Joe

Is this a BPD FICM or an oem FICM?

Pwraddr · #3 (**permalink**) 12-09-2012, 06:19 AM

Does BPD tune the FICM also?

***sinner6.0L*** · #4 (**permalink**) 12-09-2012, 07:13 AM

Quote:

Originally Posted by Pwraddr

Does BPD tune the FICM also?

BPD only sells the power side of the ficm. The tune goes in the logic side, which rarely fails

4realestate · #5 (**permalink**) 12-09-2012, 07:38 AM

Stock FICM.

Quote:

Originally Posted by PGreenSVT

Is this a BPD FICM or an oem FICM?

**PGreenSVT** · #6 (**permalink**) 12-09-2012, 11:06 AM

It would involved a tiny resistor soldered on the power board.

4realestate · #7 (**permalink**) 12-09-2012, 12:02 PM

Do you (or anyone else) have any pics of what something like that would look like so I can open this up and see if I have been sold a fabrication ?

Joe

Quote:

Originally Posted by PGreenSVT

It would involved a tiny resistor soldered on the power board.

4realestate · #8 (**permalink**) 12-09-2012, 03:59 PM

Here is what I have :

4realestate · #9 (**permalink**) 12-09-2012, 04:14 PM

**PGreenSVT** · #10 (**permalink**) 12-09-2012, 05:54 PM

Yep, that's not factory. Put it on and measure your voltage with a multi meter.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Remove Advertisements Sponsored Links
Powerstroke.org Advertisement