locking hubs???

STRKTHS73 · #1 (**permalink**) 08-09-2011, 04:22 PM

so this past weekend i pretty much grenaded my pass side front locking hub and am trying to find some after market ones that will fit my 06 f350 but i havent found a single set does no one make after market hubs for these trucks WTF i dont want factory ones

so does anyone make em or am i S.O.L. an have to get factory ones

**Raul@Stealth Automotive** · #2 (**permalink**) 08-09-2011, 04:31 PM

i have yet to find any hubs that will work on 05+ trucks... and i have been looking for about 3 years now....

i think the only thing that will work is the dynatrack full kit which is about 1500-2k

**windrunner408** · #3 (**permalink**) 08-09-2011, 04:50 PM

I dont understand. Why wont any 35 spline outer dana 60 hub work on these? The only thing that differentiates these axles from other Dana 60s is that they have 35 spline outer shafts and unit bearings as opposed to a spindle and hub. Therefore I was under the impression that they had the same splines on the unit bearing hub as the regular spindle hubs.

STRKTHS73 · #4 (**permalink**) 08-10-2011, 03:25 PM

yeah im not trying to spend about 2k on hubs i just want to replace the grenaded one and just wanted to get some upgraded hd ones im surprised with as long as these trucks have been out no one has made hubs for them yet seems kinda dumb

**windrunner408** · #5 (**permalink**) 08-10-2011, 03:27 PM

Call Dynatrac and ask them if you havent already done so.

STRKTHS73 · #6 (**permalink**) 08-10-2011, 03:30 PM

they only make a full conversion kit

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Remove Advertisements Sponsored Links
Powerstroke.org Advertisement