DIY-SCT Livewire mount

MWilbur516 · #1 (**permalink**) 03-08-2011, 02:39 PM

Cut out of plate aluminum. Then I added velcro to the back of the Livewire device and the mount itself, that way I can remove it to load tunes and update the device. I bolted it up to an unused insert on the dash. I believe this is where the automatic 4x4 selector is on equipped trucks (I have manual 4x4). I also used a snap-in 3/8 romex connector to hold the wire in place. I put it up high enough to see, but not obstruct my view.

MWilbur516 · #2 (**permalink**) 03-08-2011, 02:49 PM

Sorry guys, another member asked me for some pics of my Livewire mount and I couldn't figure out how to send the pics in a PM, so I just started a new thread and attached the pics. I hate to just take up space, but couldn't get it to work any other way. Computers are too damn complicated! HAHAHA.

rollincoal01 · #3 (**permalink**) 03-08-2011, 03:14 PM

Ok Sweet! Now I know where to start. I like the bracket you made. I cant Believe they dont already make a bracket for this in the first place haha. Thanks for the Pics bud!

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Remove Advertisements Sponsored Links
Powerstroke.org Advertisement