Does anyone know if the threads for the EGT probe on the HyperPAC and the Livewire are the same? I'm using an X2 and was using the HyperPAC as a gauge pod cause I didn't like the way it tuned the truck until it got stolen. Trying to decide if I should replace the HyperPAC, which would be cheaper since I already have the EGT set up, or just go to the Livewire. I'm lazy, and don't want to plug, re-drill, and tap my manifold. I've tried research it for myself, but I'm over here at "an undisclosed location in SW Asia" and navigating the web is proving to be more difficult than enjoying the food. But I can get on here, go figure.