Wow Not oem shocks?

Strokinallday · #1 (**permalink**) 09-08-2010, 10:40 AM

So I ordered a pair of monroe shocks and picked them up from NC when I went down for Labor day came home (NOVA) to put them on my 07 250 and got the old one off, hard to get to so i took a cutting wheel to it but I went to put the new ones on and no fit, too short, went to advance and picked up another set and they were the same length as the others i had bought too short. My Truck Is a Outlaw Lariat and I didnt have a lift that I knew of but any suggestions im kinda sitting dead in the water with no right front shock... I measured from bottom pin hole to top of rod on my old one that i cut in half and got 23 and 3/4 extended and 16 and 1/2 compressed... Please help have a major job opp and im with out a vehicle to drive to PA now.

gary2070 · #2 (**permalink**) 09-08-2010, 10:57 AM

What is the part number for those Monroe Shocks? Is your truck a 4x4?

Strokinallday · #3 (**permalink**) 09-08-2010, 11:05 AM

32356, or p10160bb

gary2070 · #4 (**permalink**) 09-08-2010, 11:09 AM

Are those for a two wheel drive or four wheel drive?

Strokinallday · #5 (**permalink**) 09-08-2010, 11:46 AM

Yes 4wd 6.0 PSD 2007 Outlaw Lariat package...

gary2070 · #6 (**permalink**) 09-08-2010, 11:52 AM

Those shocks they sold you are probably for a two wheel drive and are too short. The four wheel drive shocks would be longer.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Remove Advertisements Sponsored Links
Powerstroke.org Advertisement