|
|
|
- HOME
- FORUMS
- GARAGE
- ARTICLES
- CHAT
- CLASSIFIEDS
- VIDEOS
- TECH
- STORE
- SPONSORS - - REGISTER - CALENDAR - SITE HELP - ARCADE - STAFF - MEMBERSHIP - GET A QUOTE |
|
Welcome to the Ford Powerstroke Diesel Forum, the fastest growing Ford Diesel Community on the internet! You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact contact us |
|
|||||||
|
|
|
![]() |
|
|
LinkBack | Thread Tools | Display Modes |
|
|||
|
Eh! Finally got my new service box on 2003 truck. After first week dealer put new clutch fan and egr. Then said HPO was to low didn't want to start. Put in new sensor, regulator and pump. Go to pick up the truck leave the yard and cant get over 2500 rpm out of it and its blowing smoke. Drove arond the block and it cleared and and was good. After sitting for more than 20 minutes it will do the same and hten run good. Morning is worst takes about 10 kilometres to straighten out. Put a little performanc formula in. Might have helped some. Should I suspect bad injectors? Dealer said it had no codes an test drove 20 k's, runs rough when cold possible weak injector. Somtimes its really frustrating to drive. Any suggestions?
|
| Sponsored Links |
|
|
|
|||
|
Injectors
Picked my truck up from the dealer today. They replaced all 8 injectors. Runs great know, I'm pretty happy!!
|
| Sponsored Links |
|
|
![]() |
| Thread Tools | |
| Display Modes | |
|
|