Codes after studs and HG

[Damitman]

I have 3 trouble codes according to my Edge p0264,p0266,p0405.

It is running rough and smoking white from the exaust .I here that is normal after a blown oil cooler repair . Where should I start to fix these codes .

Thanks, Shane

[mudrunninpig]

p0405 is an egr recirculation code, did you recently do an egr delete? that would make it throw that code.

p0264 and p0266 are cylinder # 2 codes it could be a bad injector ( which could be your white smoke) or it could be the FICM. have you checked your FICMs voltage? if it is good, I would clear the codes and see if it comes back. if it does I would suspect #2 injector needs replacing.

[Damitman]

thanks for the reply. After going over my work looks like I unpluged the #2 injector when putting the air filter piping ot turbo. I lost one the clips that hold the plug in place. I will have to find a new one.
The only code I have now is the EGR which was removed so that makes sense.

All is good in my 6.0 world.........Hope it stays that way

[mudrunninpig]

good deal, glad to hear you found the problem. you can get a tuner to shut off the cel if it bothers you.