[Fatsix]

is there anyway to torque the pinion nut with the carrier in? I installed a detroit locker in the rear with new bearings. I put the carrier in before i torqued the nut. It was so hard to get in, that i dont really want to take it out. My yoke is also very hard to get on. I almost broke the puller getting it off. The impact gun is balls out and I almost have the bearings seated, but the washer is no where near crushed and the yoke isnt all the way on. I have the big 3/4 ratchet home from work and was going to use the weight of the truck... but i was told i nead to pull the carrier and check roll on the pinion and set it at 14" pounds. ugh