Quote:
Originally Posted by redoil
Do you think the 6.0 cooler will fit in place of the stock cooler on my 2000 Excursion psd?
|
The change was a no brainer! The 6.0 even bolts into the oem holes of the smaller 7.3 cooler. I took the rubber flap off the top, removed the grill, removed the 7.3 cooler and used a brass hose barb arangement to connect the original cooler lines to the new cooler. One thing is that the 7.3 has smaller cooler lines than the 6.0. So you'll need to go from a 3.8" inverted flair female to a 1/2" hose barb and then run 1/2" transmission hose to the cooler. I believe I used about 4' of the 1/2' hose for each side. On the passenger side I had to make a big loop in order to not kink the hose.