I finally finsihed the rize install.It is pretty basic and easy to do.The only problem I have is the frt diff angle is to far down after the alignment was done so the frt driveshaft binds when 4 wheeling.You want to run lots of caster at leat 3.5 degrees on these trucks so when you do this it pulls you pinion angle down which makes a bad angle in the frt.I also had to put a 1 piece drive shaft in the rear.Once it was installed it eliminated all vibrations.if I had to do this all over again i would do 8 inch lift with 38s on 20 inch wheels.It seems like 10 inch lift maxes steeing/suspension to much to be real reliable when 4 wheeling hard